Juniper JUNOSE 11.2.X MULTICAST ROUTING - Page 30

• Prefix—Value of the logical AND of the IP address of the destination network and
the subnet address
• Length—Length of the subnet mask in bits
• Type—Protocol type for the interface
• Connect—Subnet directly connected to the interface
• Static—Static route
• protocol-name—Route learned through the named protocol
• Next Hop—IP address of the next hop for this route
• Dist—Distance configured for this route
• Met—Learned or configured cost associated with this route
• Intf—Type of interface and interface specifier for the next hop. For details about
interface types and specifiers, seeInterface Types and Specifiers in JunosE Command
Reference Guide.
• Example 1
host1#show ip rpf-route
Protocol/Route type codes:
I1- ISIS level 1, I2- ISIS level2,
I- route type intra, IA- route type inter, E- route type external,
i- metric type internal, e- metric type external,
O- OSPF, E1- external type 1, E2- external type2,
N1- NSSA external type1, N2- NSSA external type2
L- MPLS label, V- VR/VRF, *- indirect next-hop
Prefix/Length Type Next Hop Dist/Met Intf
------------- ---- -------- -------- ------
10.10.0.112/32 Static 192.168.1.1 1/1 fastEthernet0/0
10.1.1.0/24 Connect 10.1.1.1 0/1 atm3/0.100
25.25.25.25/32 Connect 25.25.25.25 0/1 loopback0
• Example 2
host1#show ip rpf-route static
Protocol/Route type codes:
I1- ISIS level 1, I2- ISIS level2,
I- route type intra, IA- route type inter, E- route type external,
i- metric type internal, e- metric type external,
O- OSPF, E1- external type 1, E2- external type2,
N1- NSSA external type1, N2- NSSA external type2
L- MPLS label, V- VR/VRF, *- indirect next-hop
Prefix/Length Type Next Hop Dist/Met Intf
------------- ---- -------- -------- --------------
10.10.0.112/32 Static 192.168.1.1 1/1 fastEthernet0/0
• See show ip rpf-route.
Copyright © 2010, Juniper Networks, Inc.8
JunosE 11.2.x Multicast Routing Configuration Guide