• Use to clear the counters for multicast packet statistics on all interfaces or a specified
interface.
• Specify an interface type and specifier, such as atm 3/0, to clear the counters on that
interface. For details about interface types and specifiers, see Interface Types and
Specifiers in JunosE Command Reference Guide.
• If you do not specify an interface, the router clears the counters on all interfaces.
• Example
host1#clear ip pim interface atm 3/0.5 count
• There is no no version.
• See clear ip pim interface count.
clear ip pim remote-neighbor count
• Use to clear the counters for remote neighbor statistics on all interfaces or the specified
interface.
• Specify the IP address of an interface to clear the counters for that interface.
• If you do not specify an interface, the router clears the counters on all interfaces.
• Example
host1#clear ipv6 pim remote-neighbor 1001::1 count
• There is no no version.
• See clear ip pim remote-neighbor count.
Monitoring PIM
You can display information about PIM events and parameters.
Monitoring PIM Events
You can use the debug PIM commands to view information about PIM events.
debug ip pim
• Use to show information about the selected event.
• To control the type of events displayed, specify a severity level.
• To control how much information to display, specify a verbosity level.
• Example
host1#debug ip pim events severity 1 verbosity low
• Use the no version to disable the display.
• See debug ip pim.
undebug ip pim
107Copyright © 2010, Juniper Networks, Inc.
Chapter 3: Configuring PIM for IPv4 Multicast
To Next Page
Loading...