• Use to clear DVMRP routes from the routing table.
• If you do not specify any options, the router removes all routes except those associated
with its own interfaces from the DVMRP table.
• If you specify an IP address but not a subnet mask, the router removes the longest
route to that IP address from the DVMRP table.
• If you specify a subnet mask, the router removes that specific route from the DVMRP
table.
• Example
host1:boston#clear ip dvmrp routes
• There is no no version.
• See clear ip dvmrp routes.
Configuring DVMRP Tunnels
DVMRP tunnels enable the exchange of IP multicast traffic between routers separated
by networks that do not support multicast routing. For information about DVMRP tunnels,
see Configuring IP Tunnels in the JunosE IP Services Configuration Guide.
Monitoring DVMRP
You can establish a reference point for DVMRP statistics by setting the statistics counters
to zero.
You can display DVMRP information with the show ip dvmrp commands.
baseline ip dvmrp
• Use to set the counters for DVMRP statistics to zero, which establishes a reference
point, or baseline, for DVMRP statistics.
• Example
(host1)#baseline ip dvmrp
• There is no no version.
• See baseline ip dvmrp.
show ip dvmrp
• Use to display DVMRP information for a VR.
• Field descriptions
• Dvmrp Administrative State—State of DVMRP in the software: Enabled or Disabled
• Mcast Administrative State—State of multicasting in the software: Enabled or
Disabled
• Dvmrp Version—Version of DVMRP with which this software is compatible
Copyright © 2010, Juniper Networks, Inc.132
JunosE 11.2.x Multicast Routing Configuration Guide
To Next Page
Loading...
Need help?
General
