Juniper JUNOSE 11.2.X MULTICAST ROUTING

• You can specify either MLD proxy version 1 or 2. The default is version 2.
• Example
host1(config-if)#ipv6 mld-proxy
• Use the no version to disable MLD proxy on an interface.
• See ipv6 mld-proxy.
ipv6 mld-proxy unsolicited-report-interval
• Use to specify, in tenths of a second, how often the upstream interface should transmit
unsolicited reports.
NOTE: Issue this command only on the upstream interface. Otherwise, this command
has no effect.
• Example
host1(config-if)#ipv6 mld-proxy unsolicited-report-interval 600
• Use the no version to transmit unsolicited reports using the default value, 100-tenths
of a second (10 seconds).
• See ipv6 mld-proxy unsolicited-report-interval
ipv6 mld-proxy version
• Use to set the MLD proxy version for the interface.
• Example
host1(config-if)#ipv6 mld-proxy version 1
• Use the no version to set the version to its default value, MLDv2.
• See ipv6 mld-proxy version.
Setting the MLD Proxy Baseline
You can set the counters for the numbers of queries received and reports sent on the
upstream interface to zero. This feature allows you to establish a reference point for MLD
proxy statistics.
baseline ipv6 mld-proxy interface
Copyright © 2010, Juniper Networks, Inc.202
JunosE 11.2.x Multicast Routing Configuration Guide