• Use to disable IGMP on a VR.
• Example
host1(config)#virtual-router boston
host1:boston(config)#router igmp
host1:boston(config-router)#igmp disable
• Use the no version to enable IGMP on a VR.
• See igmp disable.
router igmp
• Use to create and enable IGMP on a VR or to access IGMP Router Configuration mode.
• Example
host1(config)#virtual-router boston
host1:boston(config)#router igmp
• Use the no version to remove IGMP and the IGMP proxy from the VR.
• See router igmp.
Monitoring IGMP
You can establish a reference point for IGMP statistics by setting the statistics counters
to zero.
To display IGMP parameters, use the show commands described in this section.
NOTE: The E120 and E320 routers output for monitor and show commands is identical
to output from other E Series routers, except that the E120 and E320 routers output
also includes information about the adapter identifier in the interface specifier
(slot/adapter/port).
baseline ip igmp
• Use to set the counters for IGMP statistics to zero, to establish a baseline.
• Example
(host1)#baseline ip igmp
• There is no no version.
• See baseline ip igmp.
show ip igmp
• Use to display IGMP information for a VR.
• Field descriptions
• Routing Process—Routing process for this VR (IGMP)
• Administrative state—Status of IGMP in the software: enabled or disabled
59Copyright © 2010, Juniper Networks, Inc.
Chapter 2: Configuring IGMP
To Next Page
Loading...