Juniper JUNOSE 11.2.X MULTICAST ROUTING - Monitoring MLD Proxy

• Use to set the counters for the numbers of queries received and reports sent on the
upstream interface to zero.
NOTE: Issue this command only on the upstream interface. Otherwise, this command
will have no effect.
• Example
(host1)#baseline ipv6 mld-proxy interface
• There is no no version.
• See baseline ipv6 mld-proxy interface.
Monitoring MLD Proxy
To display MLD proxy parameters, use the following show commands.
show ipv6 mld-proxy
• Use to display MLD proxy parameters for a VR.
• Field descriptions
• Routing Process—MLD proxy protocol
• Administrative state—State of MLD proxy in the software
• Operational state—Operational state of MLD proxy: enabled or disabled
• total interfaces—Number of MLD proxy interfaces on the VR; currently only one
upstream interface per VR
• state—Operational state of the MLD proxy interfaces: enabled or disabled
• multicast group—Number of multicast groups associated with MLD proxy interfaces
• Example
host1#show ipv6 mld-proxy
Routing Process MLD Proxy, Administrative state enabled, Operational state
enabled
total 1 upstream interface, state enabled
1 multicast group
• See show ipv6 mld-proxy.
show ipv6 mld-proxy groups
• Use to display information about multicast groups that MLD proxy reported.
• Field descriptions
203Copyright © 2010, Juniper Networks, Inc.
Chapter 6: Configuring Multicast Listener Discovery