EasyManua.ls Logo

Juniper SRX240 - Packing the SRX240 Services Gateway and Components for Shipment; Packing the Services Gateway

Juniper SRX240
198 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Locating SRX240 Services Gateway Component Serial Number and Agency Labels
on page 126
Packing the SRX240 Services Gateway and Components for Shipment on page 128
Juniper Networks Technical Assistance Center on page 118
Packing the SRX240 Services Gateway and Components for Shipment
This topic includes the following sections:
Packing the Services Gateway on page 128
Packing the Components for Shipment on page 129
Packing the Services Gateway
To pack the services gateway for shipment:
1. Retrieve the shipping carton and packing materials in which the services gateway was
originally shipped. If you do not have these materials, contact your Juniper Networks
representative about approved packaging materials.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect
the strap to the ESD point on the chassis or to an outside ESD point if the services
gateway is disconnected from earth ground.
3. On the console or other management device connected to the services gateway, enter
CLI operational mode and issue the following command to shut down the services
gateway software:
user@host> request system power-off
Wait until a message appears on the console confirming that the operating system
has halted.
4. Shut down power to the services gateway by pressing the Power button on the front
panel of the services gateway.
5. Disconnect power from the services gateway.
6. Remove the cables that connect to all external services gateway.
7. Remove all field-replaceable units (FRUs) from the services gateway.
8. If the services gateway is installed on a rack, have one person support the weight of
the services gateway while another person unscrews and removes the mounting
screws.
9. Place the services gateway in the shipping carton.
10. Cover the services gateway with an ESD bag, and place the packing foam on top of
and around the services gateway.
11. Replace the accessory box on top of the packing foam.
Copyright © 2015, Juniper Networks, Inc.128
SRX240 Services Gateway Hardware Guide

Table of Contents

Other manuals for Juniper SRX240

Related product manuals