CHAPTER 11
Installing the Services Gateway
•
Preparing the SRX240 Services Gateway for Installation on page 53
•
Installing the SRX240 Services Gateway on page 53
Preparing the SRX240 Services Gateway for Installation
You can mount an SRX240 Services Gateway in a rack. The services gateway can be
mounted on four-post (telco) racks, enclosed cabinets, and open-frame racks.
Table 31: SRX240 Services Gateway Preinstallation Checklist
Additional InformationTask
“General Site Guidelines for Installing the SRX240
Services Gateway” on page 30
Verify that the installation site meets the
requirements.
“Unpacking the SRX240 Services Gateway” on
page 51
Remove the services gateway chassis from
the shipping carton.
“Verifying Parts Received with the SRX240 Services
Gateway” on page 51
Verify the parts you have received.
Related
Documentation
General Site Guidelines for Installing the SRX240 Services Gateway on page 30•
• Unpacking the SRX240 Services Gateway on page 51
• Verifying Parts Received with the SRX240 Services Gateway on page 51
• Installing the SRX240 Services Gateway on page 53
Installing the SRX240 Services Gateway
You can front-mount or center-mount the SRX240 Services Gateway in a rack.
NOTE: If you are installing multiple devices in one rack, install the lowest one
first and proceed upward in the rack.
53Copyright © 2015, Juniper Networks, Inc.
To Next Page
Loading...
