CHAPTER 15
Performing Initial Configuration
•
SRX240 Services Gateway Software Configuration Overview on page 79
•
Connecting to the SRX240 Services Gateway Setup Wizard on page 83
•
SRX240 Services Gateway Secure Web Access Overview on page 84
•
Connecting the SRX240 Services Gateway to the CLI on page 85
•
Viewing Factory Default Settings of the SRX240 Services Gateway on page 87
•
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
CLI on page 94
•
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
J-Web Interface on page 97
•
Configuring PoE Functionality on the SRX240 Services Gateway on page 101
SRX240 Services Gateway Software Configuration Overview
This topic includes the following sections:
•
Preparing the SRX240 Services Gateway for Configuration on page 79
•
Understanding the Factory Default Configuration on page 80
•
Understanding Built-In Ethernet Ports and Initial Configuration on page 80
•
Mapping the Chassis Cluster Ports on page 81
•
Understanding Management Access on page 82
Preparing the SRX240 Services Gateway for Configuration
The services gateway is shipped with the Juniper Networks Junos operating system (Junos
OS) preinstalled. When the services gateway is powered on, it is ready to be configured.
You can perform the initial configuration of the services gateway by using the
browser-based setup wizard or by using the command-line interface (CLI).
Before configuring the services gateway, gather the configuration information required
to deploy the services gateway in your network. At minimum, the setup wizard requires
the following information:
•
Device name to be used on the network
79Copyright © 2015, Juniper Networks, Inc.
To Next Page
Loading...
