No.
Item Reference picture/drawing Procedure
2-21
13
)
Base plate assembly
<Removal>
1)Remove the screw (S2) and take out the assem-
bly.
<Attaching>
1)Attach the assembly to the boss (L14) as if insert-
ing, then clamp with the screw.
14
⁄
Entrance guide base assembly,
¤
Worm wheel 2,
‹
Timing belt, <Removal>
1) The entrance guide base assembly can be removed
by removing the screw (S2). Other parts can be
removed by simply pulling them out.
<Attaching>
1) Reverse the removal procedure. See Fig.. 2-7-14(b)
for the worm wheel 2.
Fig. 2-7-13
›
Center gear assembly
Fig. 2-7-14(a)
Fig. 2-7-14(b) Attaching Worm Wheel 2
¤
Align the phase of the rotary encoder assembly
¢
, then attach the main deck assembly by align-
ing the phase hole with the rotary encoder as-
sembly.
25
(
S2
)
20
(
L14
)
26
(
S2
)
21
22
24
23
34
22
Phase alignment
Marking
(Red)
2-20
To Next Page
Loading...
