JVC GY-DV500U - VF Display Screen

3-5
3.4.2 Operation Procedure
(1) Open the right side cover and set the DIP switch SW901-1 on the ROM board to ON (up).
(2) When the cursor on the left of an item is blinking and the adjustment value is lit steadily, rotating the SHUTTER/MENU dial selects
the adjustment item. Rotate this dial continuously to turn over the page of the MENU screen.
(3) When the cursor on the left of an item is blinking and the adjustment value is lit steadily, pushing the SHUTTER/MENU dial causes
the selected item to blink.
(4) When the cursor on the left of an item is blinking and the adjustment value is blinking, rotating the SHUTTER/MENU dial varies the
adjustment value.
(5) When the cursor on the left of an item is blinking and the adjustment value is blinking, pushing the SHUTTER/MENU dial stores the
adjustment value in memory and returns to the adjustment item selection step.
(6) Set the DIP switch SW901-1 on the ROM board to OFF (down) to exit from the adjustment mode.
Cursor
Blinking
Blinking
Steady lighting
Blinking
Adjustment Value
Selects an adjustment item. Adjustment value blinks.
Varies an adjustment value. Stores adjustment value in memory.
Rotate
Functions of SHUTTER/MENU Dial
Push
SHUTTER/MENU Dial
MAC– ERA ADJUST MENU– 2 / 6
DSP I N BLACK<B> : 128
DSP I N BLACK<R> : 1 2 8
DSP data
<Bch> <Gch> <Rch>
MASTER BLACK : 128
000
NAM APL:32
Cursor
Adjustment item
Adjustment value
Adjustment Menu
3.4.3 Flowchart of ADJUST MENU
FLARE B : O
FLARE R : O
ABL ADJUST :O
DSP data
<Bch> <Gch> <Rch>
32 32 32
C– AMERA ADJUST MENU– 5 / 6
HFO
ET ST OUT LEVEL : O
C– AMERA ADJUST MENU– 1 / 6
DSP I N BLACK<B> : O
DSP I N B LACK<R> : O
MASTER BLACK : O
DSP da t a
<Bch> <Gch> <Rch>
000
NAM APL:32
C– AMERA ADJUST MENU– 2 / 6
AGC I N BLACK<G> : O
AGC I N BLACK<B> :O
AGC I N BLACK<R> : O
DSP data
<Bc h> <Gch> <Rc h>
000
C– AMERA ADJUST MENU– 3 / 6
IN GAIN G :O
IN GAIN B :O
IN GAIN R :O
DSP data
<Bch> <Gch> <Rch>
438 438 438
C– AMERA ADJUST MENU– 4 / 6
IRIS LEVEL :O
C– AMERA ADJUST MENU– 6 / 6
3-4