3-24
3.7.13 IEEE1394 ID Setting
The GY-DV500 stores the ID in the format specified by the
IEEE1394 standard in the EEPROM (IC103 on DV Main board).
After replacing the EEPROM or the DV Main board, it is required
to re-set the ID. The setting is possible with either of the meth-
ods outlined below.
1. Setting by manual input
(1) Under the [
Option] tab of the adjustment software, click the
[
IEEE1394 ID Setting]. The window as shown below appears.
3.7.14 Active Head Cleaner Adjustment Mode
When adjusting the installation position of the active head
cleaner, use this mode to force the active head cleaner ON for a
certain period. (See subsection 2.7 No. 20 for the adjustment
procedure.)
(1) Under the [
Adjustment] tab, click [Active Head Cleaner Ad-
justing...]. The window as shown below appears.
(2) The ID (“ID : 0401xxxx” : NTSC, “ID : 0481xxxx” : PAL) is
indicated on the ID label number attached to the DV Main
board. Input characters corresponding to “0401xxxx” for
NTSC or “0481xxxx” for PAL.
(3) Click “Write” to write the ID in the EEPROM.
2. Setting with ROM Tools
(1) Read the data saved in the EEPROM to be replaced. (See
3.7.12.
3.)
(2) Save the read data in a PC file. (See 3.7.12.
2.)
(3) After the EEPROM replacement, connect the adjustment
software to the GY-DV500.
(4) Load the data saved in the PC file. (See 3.7.12.
1.)
(5) Write the loaded data in the EEPROM. (See 3.7.12.
4.)
(6) Now that the adjustment data in the new EEPROM has been
overwritten by the data in the previous EEPROM. Re-adjust
the DV circuit as required.
Fig. 3-7-15
(2) Click [
START] to set to “REC PAUSE” mode.
(3) Click [
ACH ON]. The active head cleaner will turn on in about
3 seconds.
(4) Adjust the installation position as described in the adjust-
ment procedure.
Fig. 3-7-16
3-23
To Next Page
Loading...
