16
3 Initial Setup
Turning the TV On for the First Time
1. Connect one end of the RF coaxial cable to the aerial socket on the wall and the other end of the cable to the ANT socket on
the back of your TV.
2. Connect the mains cable to the socket on the TV marked AC IN and then plug it into a mains wall socket and switch on at the
mains.
3. In standby mode, press the
button on the remote control to turn the TV on. The LED indicator will flash for a few seconds
then the TV will switch on.
Always disconnect the TV from the mains socket when not in use for a long period of time.
The
button on the remote control is only used for switching the TV into standby, it does not disconnect the TV from the
mains power. To completely disconnect the mains power, please remove the mains plug from the mains socket.
Chapter
3
HDMI1
(ARC)
HDMI 2
HDMI3
LAN
ANT.
DIGITAL
AUDIO
Router
(not included)
RF coaxial cable
(not included)
5V 500mA
1 - USB -2
Do not connect the TV to the
mains supply until you have
completed all the connections.
Initial Setup
JVC 32' Amazon Fire LED Smart HD TV LT-32CF600 Manual.indd 16JVC 32' Amazon Fire LED Smart HD TV LT-32CF600 Manual.indd 16 21/01/2021 12:3021/01/2021 12:30
To Next Page
Loading...
