121
Replay Settings
playback:
• override_rate: -1 If this number is <= 0, use Adaptive Data Replay. If this number is > 0,
use the value as the fixed replay rate. i.e. 0.5 would be to replay the data at half speed, etc.
• pause_at: [ ] - Comma separated list of times in the replay that you would like the replay
to pause at. i.e. [25, 160, 320] would pause replay at 25 seconds. You can resume replay by
hitting the spacebar key in the terminal window. Replay then will pause again at 160
seconds and so on.
• max_processing_time: 3.0 - Maximum "real" time in seconds to wait for a single scan to
process when running in Adaptive Data Replay. If processing time exceeds this time, it will
skip to the next scan to process.
To Next Page
Loading...