Chapter 6
174 Kaba Ilco Lodging Access Control System
Use the keypad to enter the day of the month. To correct a mistake done using
the keypad, use the left <W> arrow; this applies for all numeric entries done in
this section.
Select the Month option with the down <T> arrow. Use the left <W> or right
<X> arrow to select the correct month.
Finally select the Year option if needed and enter the year with the keypad.
When all 3 parameters are correct, press <
>.
4. To change the time, use the up <S> or down <T> arrow to select the “Std
Time:”. Change the time to the correct LOCAL STANDARD TIME (NOT
daylight saving time). Refer to Section3.2.3.3 – Entering Time: for how to enter
the time.
Press < > to save the parameters. The time shown will be STNADARD TIME.
If required, dependent on the time of year, set DST when the FDU features are
set in Step 6.
To Next Page
Loading...
