SAM
®
RF Operations Manual 8
Section 1: Introduction
© SAFLOK WL 12/19/2007
Quick Reference Guide (continued)
Auditing Locks
1. At the main SAM RF screen, click Utility Device.
2. Click Download Audit Trail from Lock(s).
3. Wait for the computer screen to display “The write operation was successful,” then click OK.
4. Disconnect the USB cable from the back left side of the electronic key encoder base. Keep the other
end connected to the top of the Utility Device.
5. Remove the Utility Device from the base and take it to the lock.
6. Remove the rubber cover on the lock’s receptive port and connect the USB cable to the receptive
port.
7. The utility device will beep two times and display “Operation completed.” Remove the USB cable from
the lock and replace the rubber cover on the receptive port.
8. Return the Utility Device to the base and reconnect the USB cable to the back left side of the
electronic key encoder.
9. At the main SAM RF screen, click Utility Device.
10. Click Upload Audit Trail Info From Utility Device.
11. When the Confirmation screen appears, click Yes.
12. When the Success screen appears, click OK.
13. At the main SAM RF screen, click Reports.
14. Click Lock Audits.
15. When the Lock Audit Report screen appears, highlight the unit number and click View Report.
16. When the Output Options screen appears, select Preview and click OK.
17. The report will appear on the screen. When finished reviewing, click File then Exit.
18. The Output Options screen will appear again. Click Close.
Programming Locks
1. At the main SAM RF screen, click Utility Device.
2. Click Program Locks.
3. At the Program Locks screen, check box next to the lock(s) you wish (up to 100) to program and click
OK.
4. Wait for the computer screen to display “The write operation was successful.” then click OK.
5. Disconnect the USB cable from the back left side of the electronic key encoder base. Keep the other
end connected to the top of the Utility Device.
6. Remove the Utility Device from the base and take to the lock.
7. Press Home/0 to display the lock numbers and select the lock number you wish to program.
8. Remove the rubber cover on the lock’s receptive port and connect the USB cable to the receptive
port.
9. The Utility Device will beep two times and the Utility Device will display “Operation completed.”
Remove the USB cable from the lock and replace the rubber cover on the receptive port.
10. Return the Utility Device to the base and reconnect the USB cable to the back left side of the
electronic key encoder.
Note: If you are unable to perform any of these transactions, please see your system administrator
(you may not have permission to perform these tasks). Please consult the following sections for more
detailed information.
To Next Page
Loading...