SAM
®
RF Operations Manual 107
Section 5: Keys
© SAFLOK WL 12/20/2007
Creating Latch/Unlatch Keys (continued)
5. You must name the person to whom you wish to assign the key in the
box under the words, “The Key Is Assigned To.” Click the button to the
right of the box. (This button has a hand pointing to the right.) This will
display the Select User Type PC dialog box. Click the open circle next
to Staff and click OK.
Note: Latch/Unlatch keys can only be assigned to staff members.
6. At the Staff List PC dialog box, any staff members
you previously entered into the system will be listed
in this box. Simply click on the name of the person to
receive this key and click Select.
7. Back at the Create Latch/Unlatch Key PC dialog box, the name of the person you selected will appear
in the box under the words, “The Key Is Assigned To”.
8. When you are satisfied with the settings for this key, insert a key into the encoder and click OK.
Note: You must keep the key in the electronic key encoder base while the key image
spins on the PC screen.
Note: Whenever you select the New Key
option, a Warning PC dialog box will
appear, indicating that creating a new key
will cancel any other keys of the same
type. If this is the first key of this type you
are creating, click Yes to proceed.
Otherwise, click No to return to the Create
Latch/Unlatch Key PC dialog box and
select the Duplicate Key option.
Note: If a key is not currently in the electronic key encoder, the PC will display an error screen until you
insert a key into the electronic key encoder.
Note: You must keep the USB cable connected between the electronic key encoder base and the PC
while the key image spins on the PC screen. The PC screen will display, “The write operation was
successful! The key ID for this key is 1.”
To Next Page
Loading...