Kaba Saflok SAM RF - 2.2 Installing the SAM RF Software on a Single Station

SAM
®
RF Operations Manual 10
Section 2: Installing the SAM RF System
© SAFLOK WL 12/19/2007
2.2 Installing the SAM RF Software on a Single Station
Note: To operate the SAM RF System from a remote computer, go to Section 2.3 “Installing SAM RF on
Client/Remote Stations”.
Important: Do not connect the key encoder and utility device until all software is installed.
1. Insert the CD into your CD-ROM drive on your PC and the Setup program should launch
automatically.
Note: If the Setup program does not auto-start, go to the Start menu and click Run. Click Browse to find
the SAMrfSetup.exe file located on the CD-ROM drive and double click on it. Back at the Run PC dialog
box, click OK.
2. Click Next at the Welcome PC dialog box.
3. Check both boxes to install the SAM application files and
the database files, then click Next at the Select
Components PC dialog box.
Important: Check both boxes on the Select Components
PC dialog box before continuing with the installation process.