SAM
®
RF Operations Manual 128
Section 5: Keys
© SAFLOK WL 12/20/2007
Creating Limited Use/Vendor Keys (continued)
11. The name of the vendor employee you selected
will now appear in the box under The Key Is
Assigned To. When you are satisfied with the
settings for this key, click OK.
Note: You must keep the key in the electronic key encoder base while the key image
spins on the PC screen.
Note: If a key is not currently in the electronic key encoder, the PC will display an error screen until you
insert a key into the electronic key encoder.
Note: You must keep the USB cable connected between the electronic key encoder base and the PC
while the key image spins on the PC screen. The PC dialog screen will display, “The write operation was
successful!”
12. Click OK on the PC dialog box screen message
to create additional limited use keys. If you have
more than one vendor or vendor employee
needing access, repeat the process for creating
a Limited Use key. Be sure to assign each key
to a specific vendor employee to be able to track
the key if necessary.
To Next Page
Loading...