SAM
®
RF Operations Manual 12
Section 2: Installing the SAM RF System
© SAFLOK WL 12/19/2007
Installing the SAM RF Software on a Single Station (continued)
8. Click Next at the Ready to Install PC dialog box.
8. Installation progress will display in the Installing PC
dialog box.
9. Click Finish at the Installation Completed PC dialog
box. The installation process is now complete.
10. Remove the SAM RF System software CD from the CD-ROM drive on your PC. Retain the CD in a
safe place in case software reinstallation is necessary.
Skip ahead to Section 2.5 to install the USB drivers.
To Next Page
Loading...