SAM
®
RF Operations Manual 150
Section 6: Locks
© SAFLOK WL 12/19/2007
Programming the Locks (continued)
Note:
You must keep all USB cables connected between the electronic key encoder base,
the utility device and the PC while the key image spins on the PC screen.
5. When the PC screen displays, “The write
operation was successful!”, click OK.
6. Disconnect the USB cable located on the back left hand side of the electronic key encoder base. The
USB cable must remain attached to the top of the utility device.
7. Remove the utility device with the USB cable attached and take it to the lock.
8. The utility device screen will display, “Ready
to Program.”
9. Press HOME/0 to display multiple lock
identifications. The first one to three lock
identifications will display on the utility
device screen. Press the Arrow Buttons
down or up to view the next three locks.
Continue pressing the Arrow Buttons up or
down until you locate the desired lock
identification number(s). Press the
appropriate number (
1, 2 or 3) on the utility
device pad of the lock identification number
you wish to program.
Note: Press Home/0 at any time to bring back the first three locks on the list. You may also press ESC to
return to the default screen with the first lock on the list.
10. You will see Ready to Program on the
utility device screen after you have selected
the lock identification.
Utility Ver.
Ready to Program
UNIT-007
Please select a door
1. UNIT-005
2. UNIT-006
3. UNIT-007
Utility Ver.
Ready to Program
UNIT-006
To Next Page
Loading...