SAM
®
RF Operations Manual 151
Section 6: Locks
© SAFLOK WL 12/19/2007
Programming the Locks (continued)
11. Connect the USB cable on the utility device to the lock’s receptive port located underneath the bottom
of the lock. You will need to remove the rubber cover on the lock’s receptive port to insert the USB
cable. Be sure the connectors of the USB cable and the lock’s receptive port match up.
12. The utility device screen will display the
message, “OPERATION COMPLETED
REMOVE DEVICE NOW Ready to
Program.” You will hear two beeps. The
lock identification has been
programmed. Remove the USB cable
from the lock. Replace the rubber cover
on the lock’s receptive port.
13. The next lock identification will appear
for programming. You may continue
programming locks if you wish.
After you have finished programming locks, return the utility device to the electronic key encoder base.
Reconnect the USB cable to the back left hand side of the electronic key encoder base.
OPERATION COMPLETED
REMOVE DEVICE NOW
Ready to Program
UNIT-006
Utility Ver.
Ready to Program
UNIT-007
To Next Page
Loading...