SAM
®
RF Operations Manual 163
Section 6: Locks
© SAFLOK WL 12/19/2007
Reloading Common Area Lock (continued)
9. The utility device will display the screen above and the
red light will flash on the lock while the utility device
reloads the common access lock.
10. When complete, the utility device screen will display
the message, “OPERATION COMPLETED REMOVE
DEVICE NOW Reload Common Acc.” You will hear
two beeps. The common access lock has been
reloaded. Remove the USB cable from the lock.
Replace the rubber cover on the lock’s receptive port.
11. Once the cable is removed from the lock the Utility
Device will return to the screen shown above. You
may continue reloading common access locks.
12. After you have finished, return the utility device to the electronic key encoder base. Reconnect the
USB cable to the back left hand side of the electronic key encoder base.
>>>
Reload Common Acc.
OPERTION COMPLETE
REMOVE DEVICE NOW
Reload Common Acc.
Utility Ver. 1.00
Reload Common Acc.
To Next Page
Loading...