SAM
®
RF Operations Manual 173
Section 7: Reports and Maintenance
© SAFLOK WL 12/19/2007
Auditing Locks (continued)
7. Connect the USB cable on the utility device to the lock’s receptive port located underneath the bottom
of the lock. You will need to remove the rubber cover on the lock’s receptive port to insert the USB
cable. Be sure the connectors of the USB cable and the lock’s receptive port match up.
8. The download process will take several
moments, during which time the utility device
screen will display the message “<<< Download
Audit” and beep every few seconds.
9. The utility device screen will display the
message “OPERATION COMPLETED
REMOVE DEVICE NOW Download Audit.” You
will hear two beeps. The lock’s audit trail has
been retrieved. Remove the USB cable from the
lock. Replace the rubber cover on the lock’s
receptive port.
10. You may continue downloading audit trails by inserting the USB cable attached to the utility device
into the locks you wish to audit.
Note: You can download audit trails for up to three unit locks or one common area lock. You will need to
return the utility device to the PC and reprogram it in order to continue auditing the next lock(s).
11. When you have finished, bring the utility device with the attached USB cable to the electronic key
encoder base and your PC.
12. Be sure that the PC is turned on, the electronic key encoder device is plugged in an electrical outlet
and the USB cable between them is properly attached (see Section 2.5 “Installing the Key Encoder
and Utility Device”).
<<<
Download Audit
OPERATION COMPLETED
REMOVE DEVICE NOW
Download Audit
To Next Page
Loading...