Kaba Saflok SAM RF - Page 37

SAM
®
RF Operations Manual 34
Section 2: Installing the SAM RF System
© SAFLOK WL 12/19/2007
Installing the Electronic Key Encoder and Utility Device (continued)
12. On your PC desktop, right click on the My
Computer icon. This will bring up a pull-down
menu. Click Properties.
13. Click on the Hardware tab, then click on Device Manager at
the System Properties PC dialog box.
14. Click on the Plus Sign (+) next to
Ports at the Device Manager PC
dialog box.
15. Important: A series of ports will
appear. Take note of the COM port
number next to CP2101USB to
UART Bridge Controller. Later, you
will need to assign this number in the
SAM RF software.
16. Click on the X in the upper right-hand
corner to close the Device Manager
PC dialog box.