SAM
®
RF Operations Manual 42
Section 3: The Site Design Process
© SAFLOK WL 12/19/2007
Entering Suite Information (continued)
4. At the Suite Add PC dialog box, type in the
designation for your first suite at the Suite Name
field. For example, you could type “Suite 01,”
“Suite A,” “West Wing,” “Suite 101,” etc., then
click Add.
The suite you just named will appear in the list
box below the Suite Name field.
5. You can continue adding additional suites in this
manner, or you may add a range of suite numbers to
the system, as long as they are in the same zone.
To add a range of suite numbers from the same
zone into the system, type the word SUITE (or
another appropriate name such as Building A, Suite)
in the Suite Name box, then go to the Add Name
Range area.
To add numeric information BEFORE the
information entered into the Suite Name box, click
the open circle in front of Prefix; to add the numeric
information AFTER the information entered into the
Suite Name box, click the open circle in front of
Postfix. Enter the range of suite numbers, such as
01 to 20, and click Add. The range of suites you just
designated will appear in the list box below the Suite
Name field.
Note: If you are using numbers, be sure to use only two-digit numbers by including a 0 in front of any
single-digit numbers. For example, use Suite 01 (not Suite 1), Suite 02 (not Suite 2), Suite 10, etc. to
ensure that the suites are listed in the proper order later in the site design process.
Note: If the information in the Suite Name box does not appear as you had intended, you can delete the
entries individually by clicking on a single entry and clicking Remove. To delete all the entries at one
time, click on the first entry, holding down the <Shift> key and clicking on the last entry to highlight
everything in the Suite Name box. Then click Remove and start over.
To Next Page
Loading...