SAM
®
RF Operations Manual 43
Section 3: The Site Design Process
© SAFLOK WL 12/19/2007
Entering Suite Information (continued)
6. After you create the appropriate list of suites, go to the
Zone for Suites pull-down box to see all the zones for
your property. The appropriate zone (such as Building
01) should be in the pull-down box. Click on the zone
name. It will then appear in the field directly under Zone
for Suites.
7. When you are satisfied that all information for this suite
or range of suites is accurate, click OK. Back at the
Suite Configuration PC dialog box, the suite or range of
suites you just added will appear in boldface type.
Continue adding individual suites or ranges of suites in
the same manner as described above. All suites added
will appear in bold in the Suite Configuration PC dialog
box until you save them in the SAM RF System.
8. When you have finished creating and designating the appropriate number of suites for your property,
click Save to store the information in the SAM RF System.
To confirm that all suite information has been saved, go back into the Suite Configuration PC dialog
box. The names of the suites you just registered should no longer appear in boldface type.
To Next Page
Loading...