SAM
®
RF Operations Manual 49
Section 3: The Site Design Process
© SAFLOK WL 12/19/2007
Entering Unit Lock Information (continued)
Saving Unit Information
When you are satisfied that all information for this unit or range of units is accurate, click OK. Back at the
Unit Configuration PC dialog box, the unit or range of units you just added will appear in boldface type.
Continue adding individual units or range of units in the same manner as described above. All units
added will appear in bold in the Unit Configuration PC dialog box until you save them in the SAM RF
System.
When you have finished creating and designating the appropriate number of units for your property, click
Save at the Unit Configuration PC dialog box to store the information in the SAM RF System. To confirm
that all unit information has been saved, go back to the Unit Configuration PC dialog box. The unit names
you just registered should no longer appear in boldface type.
To Next Page
Loading...