Page 2424 Operating Instructions Powador-proLOG_EN
Se ction 7 · Establishing a Co nnection
7 Establishing a Connection
7.1 Hardware and software requirements
If the Powador-proLOG has an internal analogue modem, you
have to use an analogue modem for communication. If the
Powador-proLOG has an internal ISDN modem, the PC also
has to have an ISDN modem for communication. A table of the
connections that are possible is contained in section 4.
Hardware
Standard PC with modem (analogue or ISDN) for a Powador-
proLOG with modem, or Ethernet network connection for
a Powador-proLOG with Ethernet connection, and the possi-
bility to send e-mail over the network.
Software
Internet browser: Internet Explorer 5.5/Netscape 6.1 (or later),
JavaScript is activated.
7.2 Direct connection to a Powador-proLOG
over a network (Ethernet)
The Powador-proLOG and the computer must be connected to
the same network. The IP addresses and the netmask for the
Powador-proLOG or computer must be in the same address
space. As soon as these requirements have been met, you can
use an Internet browser (e.g. Mozilla or Internet Explorer) to
address the Powador-proLOG at its IP address.
You can set the IP address in the “Network Connections”
module in the Windows Control Panel.
I M P O R TA N T
The Powador-proLOG must be addressed using the cor-
rect IP address and netmask. The standard IP address is
192.168.100.50, with a netmask of 255.255.255.0. This
means that the Powador-proLOG can be addressed by
a PC with IP address 192.168.100.xxx and netmask
255.255.255.0. “xxx” stands for any number between
1 and 254, although the number 50 is already assigned
to the Powador-proLOG.
To Next Page
Loading...
Need help?
General