Operating Instructions Powador-proLOG_EN Page 3535
Se ction 8 · Menu Description
8.2.2 Current Sensors
If current sensors (Powador-go) are connected, the current
measured values of the current sensors are shown here.
8.2.3 Inverter Survey
If inverters are connected and properly addressed, current and
accumulated measured values are shown here. Total yields are
displayed in the “Total for all inverters” section. The “Over-
view of individual inverters” section lists all connected invert-
ers, including address, unit status, current feed-in power and
daily yield that was reached at the time of the query. Each
inverter address is linked to the inverter details.
8.2.4 Inverter Details
This section shows all of the inverter’s measured values. You
can only select one inverter at a time from the drop-down list.
8.3 Status
8.3.1 Plant Messages
This menu item provides an overview of the possible alarm
statuses.
The Measured Value Alarms result from the criteria speci-
fied in “Admin Monitoring >> Formulas >> Criterion 0 - 4”.
The status overview lists the following information:
– Designation:
The name that was defined in “Formulas >> Criterion
1 - 4” is shown here.
– Status:
Indicates whether the criterion is defined as active or
inactive.
– Upper limit:
This shows the current upper limit value for the monitor-This shows the current upper limit value for the monitor-
ing criterion.
– Actual value:
This shows the current actual value for the monitoring
criterion.
– Lower limit:
This shows the current lower limit value for the moni-
toring criterion.
– Alarm Counter:
This shows how often the criterion exceeded a limit
value.
– Transfer Status:
Indicates whether there are currently alarm messages
that are waiting to be sent.
– Info:
This shows when the last alarm occurred.
The system alarms relate to messages that are based
on faults in the monitoring system.
– Designation:
The reason for the error message is shown here.
– Alarm Type:
Information about the type of e-mail/fax alarm mes-
sage.
– Alarm target:
Shows which contact the error message was sent to.
– Alarmzähler (Alarm counter):
This shows how often the alarm was tripped.
– Transfer Status:
Indicates whether there are currently alarm messages
that are waiting to be sent.
– Info:
This shows when the last alarm occurred.
The “E-Mail Transfer Status” shows the system’s current
status. For example, if e-mails are waiting to be sent, “busy”
is shown in the “sendstate” field. The normal status is “Ready
to Send”.
To Next Page
Loading...
Need help?
General