Operating Instructions Powador-proLOG_EN Page 3737
Se ction 8 · Menu Description
Additional settings when call acceptance = “off”
(analogue modem only)
– Connection acceptance start-up time:
Time that the unit begins answering
– Connection acceptance stop time:
Time that the unit stops answering
– Bell signals when accepting connection:
Number of bell signals until the Powador-proLOG
answers
– Connection acceptance period in sec after reset:
Time (in seconds) indicating how long the unit can be
reached after a restart
8.4.2 Default Contakt
The default setting for the Powador-proLOG is to have all
alarm messages and measured value files sent to the address
indicated in the “Standard contact” field. You can make
changes to individual alarm criteria, system messages, and
system parameters.
– Company/Person:
The company or person that is entered in this field is the
name of the contact and is displayed in the selection
boxes for addressing an alarm message.
– Street address, Postal code, Location, Phone: :
For documentation purposes only.
– Mobile phone:
Mobile phone number for alarm notification by SMS
(text message); the mobile phone number may not con-
tain formatting characters.
– Fax:
Fax number for alarm notification by fax; the fax number
may not contain formatting characters.
– E-mail:
E-mail address for alarm notification by e-mail
(max. 40 characters)
8.4.3 Date / Time
This is where you set the time and date.
8.5 Admin Monitoring
8.5.1 Network
The “Network” section is divided into four sub-sections.
1. Settings
The “PPP Server Settings” section pertains to the network
settings for the Powador-proLOG’s web server.
Server IP address
IP address of the Powador-proLOG for dialling up by modem/
ISDN/GSM (standard: 192.168.200.1). Server Network Mask:
do not change
Caller IP Address
Do not change (standard: 192.168.200.51)
Server telephone number
This telephone number is the number at which the Powador-
proLOG can be reached. The number is used as the sender’s
number when sending an SMS (text message).
LAN Interface Settings (Ethernet) pertain to the Powador-pro-
LOG’s local network settings.
Current IP address
The current IP address of the Powador-proLOG.
Request network configuration
You can choose between none, DHCP, BOOTP, and RARP.A
description of the protocols is shown on page 10.
I M P O R TA N T
Your changes are not applied until you press the “Save”
button.
AT T E N T I O N
Keep in mind that setting the time directly affects data
logging.
Deviations of a few seconds should not be corrected.
I M P O R TA N T
Your changes are not applied until you press the “Save”
button.
To Next Page
Loading...
Need help?
General