Page 3636 Operating Instructions Powador-proLOG_EN
Se ction 8 · Menu Description
8.3.2 Inverters
The Failure Messages section shows when the last alarm mes-
sage occurred, to include Alarm target and mode of communi-
cation. The Quick info section lists all connected inverters with
their address and unit status.
8.4 Configuration
8.4.1 Plant Data
Plant Data is required at various times. In the Powador-pro-
LOG, the information is used on the title page to provide
a quick system overview. The Plant Data is provided in the
“Admin Monitoring >> Formulas” section to define fault mes-
sages.
This is where you enter data about the operator, the
system power, the module types, orientation, etc.
You can also make settings related to error message
sending, scanning rate, and so forth.
– Plant Designation:
This entry appears on the start page and is included in
all alarm messages.
– Operator:
For documentation purposes only.
– Installed Power):
Used when calculating alarm criteria
– Module area (total):
Used when calculating alarm criteria
– Module Efficiency:
Used when calculating alarm criteria
– Inverter Efficiency:
Used when calculating alarm criteria
– Number of Subsystems:
Used when calculating alarm criteria
– Storage interval:
Data compression every 300, 600, 900, 1800, 3600
seconds
– Orientation:
The system’s orientation
– Tilt:
The angle of inclination of the modules
– Module type:
Module data
– Inverter type:
e.g. Powador 5000xi
– E-mail contact for data transfer:
Destination for sending measured data
– Data transfer: On/Off
– External call prefix:
Number required to reach an outside line (depends on
the telephone system)
– DTMF or pulse dialing:
Dialling method setting
– Timeout after bell signals (analog modem only):
Maximum time between two bell signals
– Installation country
– Country code
– Language
– Call Acceptance: On/Off
You can limit call acceptance on the data logger to a
specific time. More information is contained on the next
page.
– Bell signals (analog modem only):
Number of bell signals until the Powador-proLOG
answers
– Contact for daily file transfer via fax:
The daily files can also be sent by fax at a specific time.
To Next Page
Loading...
Need help?
General