EasyManuals Logo

Kaco Powador-proLOG User Manual

Kaco Powador-proLOG
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
Operating Instructions Powador-proLOG_EN Page 2525
Example:
IP address of the Powador-proLOG: 192.168.100.50
IP address of the network card (computer): 192.168.100.55
You can change the Powador-proLOG’s settings for IP address,
netmask and gateway via Admin monitoring > Network
– > Settings. Depending on your settings, the IP address may
vary. In this case, enter the correct IP address in your browser
instead of the standard address that is listed above.
7.3 Establishing a connection to a Powador-
proLOG by modem
To connect to the Powador-proLOG from a PC, you have to set
up a new dial-up connection. Setting up a dial-up connection
is different for each operating system. The instructions below
show how to do this for Windows 95/98, Windows 2000, and
Windows XP.
7.3.1 Windows 95/98
First step
Access the “DFÜ-Netzwerk“ (Dial-Up Networking) menu item
in “START > PROGRAMS > ACCESSORIES > COMMU-
NICATIONS. When you start it, the “Dial-Up Networking“
window appears.
Second step
Select “Make new connection” and enter a name (of your own
choosing) for the new connection. Also choose the modem
that you want to use for the connection. A suitable modem
must already be connected to your PC and installed.
If the Powador-proLOG has an internal analogue modem, you
have to use an analogue modem or an ISDN modem with ana-
logue simulation for communication. If the Powador-proLOG
has an internal ISDN modem, the PC also has to have an ISDN
modem for communication.
Third step
Press the “Next” button to begin setting up your connection.
On the “General” tab, enter the telephone number for the
connection where the Powador-proLOG is connected and can
be called. The remaining settings are standard and do not
have to be changed.
I M P O R TA N T
After you have made changes, saved the settings, and
restarted the unit, the Powador-proLOG can be reached
using the new parameters.
Se ction 7 · Establishing a Co nnection

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kaco Powador-proLOG and is the answer not in the manual?

Kaco Powador-proLOG Specifications

General IconGeneral
BrandKaco
ModelPowador-proLOG
CategoryData Loggers
LanguageEnglish