5 Installation and Operating Conditions
5.1 Safety
➤ Strictly forbid fire, open flame and smoking.
➤ If welding is carried out on or near the machine, take adequate measures to prevent sparks or
heat from igniting oil vapors or parts of the machine.
➤ The machine is not explosion protected!
Do not operate in areas in which specific requirements with regard to explosion protection are in
force.
➤ Ensure that required ambient conditions are maintained with regard to:
■ Ambient temperature and humidity
■ clean inlet air with no damaging contaminants,
■ explosive or chemically unstable gases or vapors,
■ acid/alkaline forming substances, particularly ammonia, chlorine or hydrogen sulfide.
➤ Ensure sufficient and suitable lighting such that the display can be read and work carried out
comfortably and safely.
➤ Keep suitable fire extinguishing agents ready for use.
5.2 Installation conditions
5.2.1 Determining location and clearances
The machine is intended for installation in an appropriate machine room. Information on distances
from walls and ventilation is given below.
The distances quoted are recommended distances and ensure unhindered access to all ma‐
chine parts.
➤ Please consult KAESER if they cannot be kept to.
Precondition The floor must be level, firm and capable of bearing the weight of the machine.
5 Installation and Operating Conditions
5.1 Safety
34
Service Manual Screw Compressor
BSD 9_5708 08 USE
To Next Page
Loading...
Need help?
General
