Fig. 39 Cooler/radiator cleaning
1 Rear of the machine
2 Direction of impacting water or steam jet (from outside to inside).
1. Seal off the air intakes of the engine and compressor air filters before starting cleaning.
2. Remove the cooler/radiator trim.
3. Clean the cooler/radiator with compressed air, water or steam jet in the opposite direction to
the cooling air flow.
4. Replace the cooler/radiator trim.
5. Remove the protective coverings from the air filters.
6. Reconnect the battery.
7. Start the machine and run up to operating temperature so that excess water is evaporated.
Clean the cooler/radiator only in a washing area equipped with an oil separator.
10.5 Chassis
➤ Note the instructions in the separate documents:
■
"Chassis maintenance"
■ Chassis manufacturer's operating instructions
10.5.1 Wheel checks
Check the wheels and tyres after the first 50 km and after every wheel change, but at least every
six months for tightness, visible damage and tyre pressures.
Material Torque wrench
Tyre pressure gauge
Precondition The machine is switched off.
1. Wheel tightness check (see chapter 2.4.3 for torques)
2. Check the tyres for any defect.
Replace any damaged or worn tyres.
3. Check tyre pressures (see chapter 2.4.2 for pressures).
10 Maintenance
10.5 Chassis
No.: 9_9432 02 E
Service Manual Screw Compressor
M43
99
To Next Page
