KanexPro MX-HDBASE8X8-4K - Page 24

4K HDBaseT™ 8x8 Matrix Switcher
MX-HDBASE8X8-4K 19
KanexPro.com
Command
Function
Feedback Example
[x]$.
Switch off the output channel [x].
X Closed.(X=1~8)
[x]@.
Switch on the output channel [x].
X Open.(X=1~8)
All@.
Switch on all output channels.
All Open.
[x1]V[x2].
Transfer the AV signal from the input
channel [x1] to one or several output
channels ([x2], separate output channels
with comma).
AV:X1->X2
(X1/X2=1~8)
[x1]B[x2].
Transfer the AV and IR signal from input
channel [x1] to one or several output
channels ([x2], separate output channels
with comma).
AV:X1->X2
(X1/X2=1~8)
Status[x].
Check the I/O connection status of output
[x]
AV: Y->X
(X=1~8, Y=1~8)
Status.
Inquire the input channel to the output
channels one by one.
AV: 1->1
AV: 2->2
AV: 3->3
AV: 4->4
AV: 5->5
AV: 6->6
AV: 7->7
AV: 8->8
Save[Y].
Save the present operation to the preset
command [Y], ranges from 0 to 9.
Save To FY
(Y=0-9)
Recall[Y].
Recall the preset command [Y].
Recall From FY
(Y=0-9)
Clear[Y].
Clear the preset command [Y].
Clear FY
(Y=0-9)
PWON.
Work in normal mode.
PWON
PWOFF.
Enter into standby mode and cut off the
power supply to HDBaseT receivers.
PWOFF
STANDBY.
Enter into standby mode. (Do not cut off
the power supply to HDBaseT receivers
press other buttons or send other
commands to start.)
STANDBY
Audio/[X]:[Y].
Select HDMI audio or analog audio as
audio source for output 1~8.
Audio/[X]:[Y].
X=1~8, Y=0 (HDMI
audio) or 1 (Analog
audio).