User's manual – C6 ECON
54 Karl E. Brinkmann GmbH
Power supply
The system must be powered with at 24V
DC
nominal (+18V÷36V),
with external cut-off (there is no main switch for the system).
• Remove the two-pole connector from the system
(sequence 1 of 3)
• Connect the positive pole and the negative one for power supply
(also see the label on the back of the machine) to the respective
terminals of the two pole connector with wires with a suitable
cross section.
(sequence 2 of 3)
To Next Page
Loading...
Need help?
General
