General description
Karl E. Brinkmann GmbH 57
Installation of software in various Windows environments
• Insert the KEB CD-ROM KEB provided and select the directory
\Touschscreen ELO.
• Select the sub-directory for the operating system being used.
• Run the file Setup.exe.
• Select the port COMx to which the operating system has associ-
ated the controller.
• Run the bootstrap as requested.
• The Touchscreen is now configured. In the control panel, there is
a new object called EloTouchscreen. It allows calibration of the
device, configuration of the "touch", of the acoustic feedback,
and diagnostic functions.
NB: if the type of controller being is used is requested, select ELO
SMARTSet Serial controller.
Installation of software in MS-DOS environment
•
Insert the ASEM CD-ROM KEB provided and select the directory
\Touschscreen ELO.
• Select the sub-directory for the MS-DOS operating system.
• Run the file Install.
• Select the language and the directory that is to be created.
• Select DOS Express Installation.
• When the type of interface of the controller is requested, select
Serial.
• Select the port COM4.
• When the type of controller is requested, select E281-2310 Intel-
litouch.
Install will update the file autoexec.bat to allow the selected drivers
to be run (the file autoexec.old will contain a copy of the previous
version of the file). The file go.bat created by the installation loads
the driver of the Touchscreen and runs the calibration programme
elocalib. if you want to change the interrupt for the driver, you must
edit the last parameter that is passed to the driver:
ELODEV 2310, 9600, 5 In this example, a controller of type 2310 is
activated on COM4, at 9600 baud and with IRQ 5.
To Next Page
Loading...
Need help?
General
