User's manual – C6 ECON
60 Karl E. Brinkmann GmbH
How to start the system
Before you power on the system, make sure that all the connections
have been properly made.
Start-up
The sy
stem is started by providing 24V DC power.
Shutdown
To shut down the system normally, you will need to follow the shut-
down pro
cedure for the operating system being used (configured so
as to support the mode APM – Advanced Power Management). At
the end of this procedure, the system will go to standby status. Only
in this status can the power supply be disconnected.
To Next Page
Loading...
