IEEE-488 Reference
5-51
5.10.9
*RCL
recall
To return the Model 7001 to a setup configuration previously stored in memory.
*RCL <n>
<NRf> = 0 to 9 Memory location
The Model 7001 can store up to 10 setup configurations in memory locations 0 to 9. Over the
bus, the *SAV command is used to save setup configurations (see paragraph 5.10.11).
The *RCL command is used to return the Model 7001 to a setup configuration stored at one of
the memory locations. For example, if a setup configuration was previously stored at memory
location 9, the Model 7001 can be returned to those setup conditions by sending the following
command:
*RCL 9
Note: The Model 7001 is shipped from the factory with :SYSTem:PRESet defaults stored in all
ten memory locations (see Table 5-5).
The following example assumes that a setup configuration has been stored at memory location
6 (see paragraph 5.10.11 for information on storing setup configurations).
OUTPUT 707; “*RCL 6” ! Recall setup stored at memory location 6.
Purpose
Format
Parameters
Description
Programming
example
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
To Next Page
Loading...
