IEEE-488 Reference
5-84
[:ROUTe] subsystem
With Card Pair enabled, the corresponding channels of the two slots are controlled concurrently.
For example, when channel 5 of CARD 1 (Slot 1) is closed, channel 5 of CARD 2 (Slot 2) is
also closed.
Card Pair can only be enabled for similar type cards. For example, you will not be able to enable
Card pair if a multiplexer card is installed in Slot 1 and a matrix card is installed in Slot 0.
If enabling Card Pair adds a restricted channel to the Scan List and/or a Channel Pattern, then
the entire Scan List and/or Channel Pattern is cleared (lost).
10 OUTPUT 707; “:conf:cpa on; cpa?”
20 ENTER 707; A$
30 PRINT A$
40 END
Line 10 Enables Card Pair and then queries its status.
Line 20 Addresses the 7001 to talk.
Line 30 Displays the status of Card Pair (1; on).
:CTYPe <name>
[:ROUTe]:CONFigure:SLOT[1]:CTYPe <name> Assign card ID number for SLOT 1
[:ROUTe]:CONFigure:SLOT2:CTYPe <name> Assign card ID number for SLOT 2
<name> = C7052 <name> = C7067
= C7053 = C7152
= C7054 = C7153
= C7056 = C7154
= C7057 = C7156
= C7058 = C7158
= C7059 = C7164
= C7061 = C7166
= C7062 = C7168
= C7063 = C7169
= C7064 = C7402
= C7065 = C9990
= C7066 = C9991
:conf:slot:ctyp <name>
:conf:slot2:ctyp <name>
Power-up Each slot uses the last programmed type, or a 701X card type that is de-
tected.
*RST No effect
:SYSTem:PRESet No effect
Description
Programming
example
5.13.8
Parameters
Short-form
formats
Defaults
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
To Next Page
Loading...
