IEEE-488 Reference
5-85
:CYTPe? Query card ID assignment for specified slot.
Short-form formats: :conf:slot:ctyp?
:conf:slot2:ctyp?
Response message: Assigned card ID (e.g. C7156)
After installing a non-701X series card in a mainframe slot, use the :CYTPe command to assign
the ID (identification) number (type) for that slot. For example, if a Model 7156 card is installed
in Slot 1, send type parameter C7156 with the command.
Type C9990 or C9991 can be used to assign a slot as a card simulator. By assigning C9990, the
instrument will operate as if a 40 channel switch card were installed in the specified slot. By
assigning C9991, the instrument will operate as if a 4 x 10 matrix were installed.
A slot assignment change could make a channel that is currently included in the Scan List and/
or a Channel Pattern unavailable. The unavailable channel causes the Scan List and/or the af-
fected Channel Pattern to clear.
This program assumes that Slot 1 is empty.
10 OUTPUT 707; “:conf:slot1:ctyp C9990; ctyp?”
20 ENTER 707; A$
30 PRINT A$
40 END
Line 10 Assigns simulator C9990 to Slot 1 and then queries the model number.
Line 20 Addresses the 7001 to talk.
Line 30 Displays the card ID number assigned to Slot 1 (C9990).
:POLE <NRf>
[:ROUTe]:CONFigure:SLOT[1]:POLE <NRf> Select pole mode for card in Slot 1
[:ROUTe]:CONFigure:SLOT2:POLE <NRf> Select pole mode for card in Slot 2
<NRf>= 1 Select 1-pole mode
= 2 Select 2-pole mode
= 4 Select 4-pole mode
:conf:slot:pole <NRf>
:conf:slot2:pole <NRf>
Power-up Last selected pole mode for each slot
*RST No effect
:SYSTem:PRESet No effect
Query
command
Description
Programming
example
5.13.9
Parameters
Short-form
formats
Defaults
[:ROUTe] subsystem
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
To Next Page
Loading...
Need help?
General
