To Next Page

To Previous Page

IEEE-488 Reference

5-65

SCPI command subsystems

SCPI commands are categorized into subsystems. The subsystems are presented in alphabetical

order as follows:

5.11 :DISPlay subsystem —

Explains the commands used to control user deﬁned text

messages.

5.12 :OUTPut subsystem —

Explains the commands used to program the polarity (active-

high or active-low) of the digital output port bits.

5.13 :ROUTe subsystem —

Covers commands used to open and close channels, deﬁne a

scan list, specify restricted (forbidden) channels, and enable/disable Single Channel

and Card Pair. Also covered are slot conﬁguration commands used to program the re-

lay settling time, pole-mode and card type of each slot. Finally, memory commands

used to store (save) and recall channel patterns are explained here.

5.14 Sense subsystems —

Explains the command used to read the digital input port of the

Model 7001 (and digital cards).

5.15 :SOURce subsystem —

Covers the commands used to set the state (0 or 1) of the dig-

ital output port bits.

5.16 :STATus subsystem —

Covers the commands used to control the status registers of

the Model 7001.

5.17 :SYSTem subsystem —

Covers miscellaneous commands used to read the software

revision level of the Model 7001, read the error queue, and set the power-on setup

conﬁguration.

5.18 Trigger subsystem —

Covers commands used to scan.

Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com

Keithley 7001 User Manual

Other manuals for Keithley 7001