Keithley 7001 User Manual

IEEE-488 Reference
5-114
:ENABle <list>
:STATus:QUEue:ENABle <list> Enable messages for Error Queue
list = (numlist)
where; numlist is a specified list of messages that you wish to enable for the Error Queue.
:stat:que:enab (numlist)
Power-up Enable error events, disable status events
*CLS No effect
:STATus:PRESet Enable error events, disable status events
:ENABle? Query list of enabled messages
Short-form format: :stat:que:enab?
Response message: numlist
On power-up, all error messages are enabled and will go into the Error Queue as they occur. Sta-
tus messages are not enabled and will not go into the queue. This command is used to specify
which messages you want enabled. Messages not specified will be disabled and prevented from
entering the queue.
When this command is sent, all messages will first be disabled, then the messages specified in
the list will be enabled. Thus, the returned list (:ENABle?) will contain all the enabled messages.
Messages are specified by numbers (see Table 4-1). The following examples show various forms
for expressing a message numlist:
Numlist = -110 Single message.
= -110, -140, -222 Messages separated by commas.
= -110:-222 Range of messages (-100 through -222).
= -110:-222, -230 Range entry and single entry separated by a comma.
Note: To disable all messages from entering the Error Queue, send the following command:
:stat:que:enab ()
To enable all Model 7001 messages, send the following command: :stat:que:enab (-150: +550)
10 OUTPUT 707; “:stat:que:enab (0:-999); enab?”
20 ENTER 707; A$
30 PRINT A$
40 END
Parameters
Short-form
format
Defaults
Query
commands
Description
Programming
example
:STATus Subsystem
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com

Keithley 7001 Specifications

General

Brand	Keithley
Model	7001
Category	Switch
Language	English