C
Controller Programs
C-1
The following programs have been supplied as a sim-
ple aid to the user and are not intended to suit speciÞc
needs. Each program allows you to send a command
message to the instrument and obtain and display a re-
sponse from the instrument for query commands.
Programs for the following controllers are included:
¥ A BASIC program for an IBM PC/XT/AT with a
Capital Equipment Corporation PC<>488 Inter-
face (Keithley Model PC-488-CEC IEEE-488 Inter-
face Card).
¥ A BASIC program for an IBM PC/XT/AT with IO-
tech Driver488 Software.
¥ A BASIC program for a Hewlett-Packard Model
9000 Series 200/300 computer.
¥ A program written with the ASYST software pack-
age (available from Keithley Instruments) for an
IBM PC/XT/AT with a Capital Equipment Corpo-
ration PC<>488 Interface.
¥ A BASIC program for an IBM PC/XT/AT with a
National GPIB PC Interface.
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
To Next Page
Loading...
Need help?
General
