Inserting the bobbin
[i7 Place the bobbin in the bobbin holder with the
thread running counter-clockwise.
_i_ End of the thread
_2_Bobbin holder
[ii_Guide the thread into slot A on the front side of the
bobbin holder. Draw the thread to the left
sliding it between the tension spring blades.
_3_ Slot A
% Continue
tension
_5_Slot B
[13Draw the thread to the back.
The bobbin should turn counterclockwise when
pulling the thread.
% Pull out about 10 cm (4") of thread and attach the
hook cover.
_6_Bobbin thread
_7_Align left edge of the hook cover,
f
%
%
To Next Page
Loading...
