Bartacking
Stitch pattern:
Thread tension dial:
Presser foot F:
19
3to6
Satin stitch foot
Set the machine to "Low" speed setting. 4 lock stitches will
be sewn first. Then sew to the desired length and press the
reverse stitch button.
The desired length has been now determined. Continue
sewing until the machines stops automatically.
* This stitch is used for reinforcement of the heavily
strengthened part of a garment.
The maximum bartack length is 1" (2.5 cm) depending
upon fabric.
When you change the stitch length or stitch width, press
width "+", or "-" or length "+" or "-" key.
Starting position
Ending position
Pre-set 5/8" (1.5 cm)
• Memorizing bartacking
When repeatedly sewing the same size bartack, restart
sewing.
Length required
Reverse stitch button
Starting position
Ending position
S
S
19 2.0 1.5
i
!
j ..... ®
• Adjusting the evenness of bartacking
Make a test on an extra piece of fabric to check your
settings. If the bartacking is uneven, adjust the stitch
length by turning the feed balancing dial as follows.
• Stitch does not meet start position 8, turn dial toward "+"
for even stitch 10.
• Stitch does not meet return position 9, Turn dial toward "-"
for even stitch 10.
®
78
To Next Page
Loading...
Need help?
General
