Automatic buttonhole
Stitch pattern: 00
Thread tension dial: 1 to 5
(_ Presser foot R: Automatic buttonhole foot
• Preparation for sewing
Groove
Pin
Attach the automatic buttonhole foot R. Make sure the
groove on the foot holder catches the pin on the foot when
lowering the presser foot.
\
f
®
0.4
J
(_) Button holder
Buttonhole lever
The buttonhole size is automatically set by placing the
button in the rear of the automatic buttonhole foot.
The button holder on the foot takes a button up to 1.0"
(2.5 cm) in diameter.
Use interfacing on stretch fabrics.
Pull the button holder (_ to the back, and place the
button in it. Push it forward tightly against the button.
Pull the buttonhole lever _ down as far as it will go.
f
J
%
60
To Next Page
Loading...
Need help?
General
