2-6 Keysight N5221A/22A Service Guide
General Product Information
Required Service Test Equipment
2-
5/16 inch, open-end torque wrench
(metric equivalent is 8 mm)
1.1 and 2.4 N-m (10 and 21
in-lb) settings (for semi-rigid
cables)
N/A N/A T, R
1 inch, open-end torque wrench
(metric equivalent is 26 mm)
8.1 N-m (72 in-lb) setting (for
Port 1 and Port 2 connector
nuts)
N/A N/A R
9-mm, socket or open-end wrench 2.38 N-m (21 in-lb) setting (for
all front panel and most rear
panel connector hex nuts)
N/A N/A R
20 mm, open-end torque wrench 0.9 N-m (8 in-lb) setting (for
measurement port
connections)
8710-1764 N/A P, A, T
Static Safety Parts
Adjustable antistatic wrist strap N/A 9300-1367 None P, A, T
Antistatic wrist strap grounding cord
(5 foot)
N/A 9300-0980 None P, A, T
Static control table mat and earth
ground wire
N/A 9300-0797 None P, A, T
Miscellaneous
USB flash ROM drive N/A Any None P, A, R
a. Unless specified otherwise, equipment listed is required for all analyzer models.
b. P = Performance tests, A = Adjustments, T = Troubleshooting, R = Repair, V = System verification
Equipment
a
Critical Specifications Recommended
Model or Part
Number
Alternate
Model
Number
Use
b
To Next Page
Loading...
