3-2 Keysight N5221A/22A Service Guide
Tests and Adjustments
Information in This Chapter
3-
About System
Verification and
Performance Tests
Descriptions of:
— System Specifications
— Instrument Specifications
— System Verification Procedure
— Performance Tests
— Certificate of Calibration
page 3-7
ANSI/NCSL Z540.3–
2006 and ISO/IEC
17025 Verification
The ANSI/NCSL Z540.3–2006 and ISO/IEC 17025 process of verifying
your analyzer.
page 3-10
Non-Standards
Compliant Verification
The Non-Standards Compliant process of verifying your analyzer. page 3-11
Preliminary Checks Performing the operator’s check.
Checking your test cables.
Perform these checks before performing system
verification.
page 3-12
System Verification What the system verification does.
How to perform the verification test.
How to interpret the results.
page 3-21
Performance Tests
a
A brief summary of each performance test:
— Source Maximum Power Output Test
— Source Power Linearity Test
— Frequency Accuracy Test
— Trace Noise Test
— Receiver Compression Test
— Noise Floor Test
— Calibration Coefficients Test
— Dynamic Accuracy Test
page 3-31
Section Title Summary of Content Start Page
To Next Page
Loading...
